|
Post by Admin on Aug 23, 2016 17:18:45 GMT -5
Pt.1
Jessie Raspbian that is installed on my Raspi 3 and the kernel is the one that is given when you download the package to use the mimo screen so I just replace the kernel img by this one. I actually can make it work when using my SD card as boot but I have to use a SSD to make my raspberry more faster and efficient. when I finally copy all the content of the SD card my raspberry is booting normally when the Mimo screen is not plugged in. If it is, I got some troubles during the second part of the boot :
" Failed to start Light Display Manager " "Failed to start Update UTMP about system Runlevel Changes" And then I get an error that refresh in an infinite loop wich is " Ext 4 -fs error (device sda1) ...... unable to read itable block"
I checked if the SSD was in ext 4 like the SD card and it is.
Pt. 2
I just found that it was a power problem that causes the raspberry to don't boot. I just tried without anything than a keyboard plugged in and the screen is working. I maybe have to find something so I can power my raspberry with the SSD and the screen together. I have now an other problem since my screen is working i just used the evtest to configure the axis , but it doesn't seem that it works. When i put my finger on the very left of the screen the cursor is under my finger further i go right further the cursor is going right. so when I put my finger on the middle on the screen the cursor is at the very left do you have some idea ?
|
|